en:ovi40build:uiboardbuild

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
en:ovi40build:uiboardbuild [07.02.2018 06:53] – [OVI40 UI V1.8 Documents] df9ts_useren:ovi40build:uiboardbuild [11.02.2018 16:06] – [Assembly and Soldering] df9ts_user
Line 82: Line 82:
  
 This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-8828-SEEPROM-AT24CM02-Datasheet.pdf|here]] This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-8828-SEEPROM-AT24CM02-Datasheet.pdf|here]]
 +
 +[{{:fr:ovi40build:20180211_144354_2.jpg?400|IC7 close-up}}]
  
 **Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02). **Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02).
  • en/ovi40build/uiboardbuild.txt
  • Last modified: 02.03.2018 18:13
  • by df9ts_user