en:ovi40build:uiboardbuild

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
en:ovi40build:uiboardbuild [03.02.2018 10:42] – [Modifications] Disco F746 added df9ts_useren:ovi40build:uiboardbuild [11.02.2018 16:06] – [Assembly and Soldering] df9ts_user
Line 16: Line 16:
  
   * {{:projekte:ovi40-sdr:uhsdr_ovi40_ui_18_sheet.pdf|OVI40 UI V1.8 schematics}}   * {{:projekte:ovi40-sdr:uhsdr_ovi40_ui_18_sheet.pdf|OVI40 UI V1.8 schematics}}
-  * [[:projekte:ovi40-sdr:bom|OVI40 UI V1.8 BOM]]+  * [[en:projekte:ovi40-sdr:bom|OVI40 UI V1.8 BOM]]
   * {{:ovi40build:parts-installation_2_ui_v1.8a.pdf |BOM von Francois F4HTX with IC Device Marks added}}   * {{:ovi40build:parts-installation_2_ui_v1.8a.pdf |BOM von Francois F4HTX with IC Device Marks added}}
  
Line 82: Line 82:
  
 This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-8828-SEEPROM-AT24CM02-Datasheet.pdf|here]] This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-8828-SEEPROM-AT24CM02-Datasheet.pdf|here]]
 +
 +[{{:fr:ovi40build:20180211_144354_2.jpg?400|IC7 close-up}}]
  
 **Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02). **Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02).
  • en/ovi40build/uiboardbuild.txt
  • Last modified: 02.03.2018 18:13
  • by df9ts_user