Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:ovi40build:uiboardbuild [31.01.2018 07:14] – df9ts_user | en:ovi40build:uiboardbuild [11.02.2018 16:06] – [Assembly and Soldering] df9ts_user | ||
---|---|---|---|
Line 16: | Line 16: | ||
* {{: | * {{: | ||
- | * [[: | + | * [[en: |
* {{: | * {{: | ||
Line 82: | Line 82: | ||
This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http:// | This is where the dot is printed. Also the edge of the case is slanted near the 1-4 pins. See [[http:// | ||
+ | |||
+ | [{{: | ||
**Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02). | **Do not solder in R101** for the EEPROM delivered with the kit (AT24CM02). | ||
Line 111: | Line 113: | ||
=== Temporary Modification: | === Temporary Modification: | ||
- | Symptom: In stand-by the current drawn from back-up battery is excessively high. Work-around: | + | Symptom: In stand-by the current drawn from back-up battery is excessively high. Work-around: |
=== Change brightness of LEDs === | === Change brightness of LEDs === |