en:uhsdr_dev:uhsdrbuild

This translation is older than the original page and might be outdated. See what has changed.

This is an old revision of the document!


Note: Attention: Work in progress - page under construction

  • UHSDR toolchain installed, see here
  • Goto https://github.com/df8oe/UHSDR and click button “clone or download”
  • Unpack the downloaded .zip file on your hard disk. Do not change the name, do not change the internal zip structure
  • In Eclipse, choose “File→Import”.
  • .. then choose “General→Existing Projects into Workspace”.
  • Then choose the folder “mchf-eclipse in the path where you just downloaded the zip file as “root-directory”
  • The project is now recognized and can be imported
  • Project → Build Configurations → Set Active → DebugLibOVI40 (OVI49 DSP Library (STM32F7))
  • Click on the “hammer” in the tool bar
  • Watch Console window in Eclipse - if all ok console output ends with ” … Build finished …“
  • Project → Build Configurations → Set Active → DebugOVI40 (OVI40 Firmware (STM32F7) …)
  • Click on the “hammer” in the tool bar
  • Watch Console window in Eclipse - if all ok console output ends with ” … Build finished …“

Newly built binary fw-ovi40.bin can be found in the eclipse project explorer (left sidebar): mchf-eclipse → DebugOVI40 → fw-ovi40.bin

With .bin file the FW can be installed via USB stick of ST-Link/V2 adapter. You may want to create a dfu file from the bin file so that the DfuSE FW install method can be used.

Section 4.2.1 of STM manual UM0412 describes step-by-step the generation of a .dfu file.

The ST-Micro UM0412 manual on DfuSe can be found here. Original source is this.

You could leave a comment if you were logged in.
  • en/uhsdr_dev/uhsdrbuild.1517904888.txt.gz
  • Last modified: 06.02.2018 08:14
  • by df9ts_user