en:uhsdr:uhsdrtroubleshooting

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
en:uhsdr:uhsdrtroubleshooting [12.02.2018 19:45] – df9tsen:uhsdr:uhsdrtroubleshooting [12.02.2018 20:03] – df9ts
Line 43: Line 43:
 === 3. Debug cable === === 3. Debug cable ===
 The debug cable shouldn't be longer than 10 cm. 3 to 4 connections are needed. The debug cable shouldn't be longer than 10 cm. 3 to 4 connections are needed.
-|< 40% 50% 50% >| +|< 60% 50% 25% 25% >| 
-|  ST-link adapter  | OVI40 UI JP8  | +|ST-link adapter  |OVI40 UI JP8  |Remark  | 
-|  Pin-9 SWCLK  |   JP8 Pin 4  | +|Pin-13 TRACESWO  |JP8 Pin 1     |Debug Output  | 
-|  Pin-7 SWDIO  |  JP8 Pin 3  | +|Pin-15 NRST      |JP8 Pin 2     |Reset         | 
-|  Pin-20 Gnd  |  JP8 Pin 6  |  +|Pin-07 SWDIO     |JP8 Pin 3     |Debug I/O     | 
-|  not essential: Signal: Reset  |  JP8 Pin 2  |+|Pin-09 SWCLK     |JP8 Pin 4     |Debug Clock   | 
 +|Pin-01 MCU VDD   |JP8 Pin 5     |VDD from MCU  | 
 +|Pin-20 Gnd       |JP8 Pin 6     |Ground        |
  
 {{ :uhsdr:en.dm00026748.pdf |Beschreibung ST-Link V2 und ST-Link ISO Adapter, Pin out}} {{ :uhsdr:en.dm00026748.pdf |Beschreibung ST-Link V2 und ST-Link ISO Adapter, Pin out}}
  • en/uhsdr/uhsdrtroubleshooting.txt
  • Last modified: 26.02.2018 18:58
  • by df9ts_user