en:ovi40build:displaybuild

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:ovi40build:displaybuild [25.04.2018 07:28] – [Display Calibration - mandatory at first bring-up] included post of Slawek df9tsen:ovi40build:displaybuild [15.05.2018 13:18] (current) – [Display Assembly] df8oe
Line 69: Line 69:
 This pdf contains th modified assembly notes: {{:projekte:ovi40-sdr:lcd_35_40pin_df8oe_sp9bsl.pdf|lcd_35_40pin_df8oe_sp9bsl.pdf}} This pdf contains th modified assembly notes: {{:projekte:ovi40-sdr:lcd_35_40pin_df8oe_sp9bsl.pdf|lcd_35_40pin_df8oe_sp9bsl.pdf}}
  
-  * C103 not needed anymore+  * C103, C112, IC103 and R106 are not needed anymore
   * R101 = R104 = 100K   * R101 = R104 = 100K
-  * R106 = 1K 
   * R102 = 15R   * R102 = 15R
 +  * R105 = 3.3R
   * all 10u now replaced by 1u   * all 10u now replaced by 1u
   * XPT2046 = ADS7843E   * XPT2046 = ADS7843E
 +
 +Put a small wire between pin3 and pin4 of IC103. Shorten R107 forever.
 +
 +LCD can only work in parallel mode - there //will never be a SPI mode.//
  
 DF8OE suggest to replace the two parallel tantal capacitors next to the 3.3V voltage regulator by 100nF & 1uF. He also suggest to put 100nF & 1uF in the free location shown in Andy's photo. DF8OE suggest to replace the two parallel tantal capacitors next to the 3.3V voltage regulator by 100nF & 1uF. He also suggest to put 100nF & 1uF in the free location shown in Andy's photo.
Line 89: Line 93:
  
 Das Doppelklebeband links in voller Höhe (überdeckt die 20pol Löcher) in ca. 1cm Breite positionieren, und dann oben und unten in ca. 5mm Breite über die volle PCB Länge. Rechts kommt KEIN Klebeband hin. Es ist zu vermeiden rechts mit Kraft auf das LCD zu drücken. Dort ist es sehr empfindlich, weil dort kein Plastik-Rand darunter ist. Das Doppelklebeband links in voller Höhe (überdeckt die 20pol Löcher) in ca. 1cm Breite positionieren, und dann oben und unten in ca. 5mm Breite über die volle PCB Länge. Rechts kommt KEIN Klebeband hin. Es ist zu vermeiden rechts mit Kraft auf das LCD zu drücken. Dort ist es sehr empfindlich, weil dort kein Plastik-Rand darunter ist.
 +
  
 ==== On shortening the male header J103 on OVI40 UI for LCD display ==== ==== On shortening the male header J103 on OVI40 UI for LCD display ====
  • en/ovi40build/displaybuild.1524641292.txt.gz
  • Last modified: 25.04.2018 07:28
  • by df9ts