Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:projekte:ovi40-sdr:aufbautipps-ui-pcb [30.10.2017 16:26] – peter_77 | en:projekte:ovi40-sdr:aufbautipps-ui-pcb [08.12.2017 16:41] – [Detailed photos] df8oe | ||
---|---|---|---|
Line 47: | Line 47: | ||
===== Detailed photos ===== | ===== Detailed photos ===== | ||
+ | |||
One picture says it all - The following photos show the fully populated UHSDR I40 UI pcb.: | One picture says it all - The following photos show the fully populated UHSDR I40 UI pcb.: | ||
- | {{: | + | Pictures coming soon! |
- | {{: | + | |
- | {{: | + | |
Line 60: | Line 59: | ||
If not, supply voltage should be removed immediately and the pcb be checked for possible errors. | If not, supply voltage should be removed immediately and the pcb be checked for possible errors. | ||
If all is fine, connect the small USB connector to a PC. | If all is fine, connect the small USB connector to a PC. | ||
- | Under Windows OS you instantly hear the typical chime for new USB components and the taskbar shows an //STM in DFU mode// in the information bubble. Linux is a bit more "silent" | + | Under Windows OS you instantly hear the typical chime for new USB components and the taskbar shows an //STM in DFU mode// in the information bubble. |
- | Linux proofs | + | |
- | If yes, bootloader and firmware can be flashed with: | + | If all is fine, bootloader and firmware can be flashed with: |
Bootloader: //dfu-util -d -R -a 0 0483:df11 -D Pfad-zur/ | Bootloader: //dfu-util -d -R -a 0 0483:df11 -D Pfad-zur/ | ||
Line 72: | Line 70: | ||
Its the same way as its done with the originally mcHF UI board. | Its the same way as its done with the originally mcHF UI board. | ||
- | Actual firmware and bootloader versions can de downloaded here: [[https:// | + | Actual firmware and bootloader versions |
If this was all successfully completed, then remove the supply voltage and also remove jumper P6. Put the LCD panel into its connectors and reconnect the +5V voltage to pin 28. | If this was all successfully completed, then remove the supply voltage and also remove jumper P6. Put the LCD panel into its connectors and reconnect the +5V voltage to pin 28. | ||
You should now see the boot process with the UHSDR bootscreen and some error messages. These messages are expected, cause of the missing RF board. | You should now see the boot process with the UHSDR bootscreen and some error messages. These messages are expected, cause of the missing RF board. |